Procedure For Malfunction A And B
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
With CONSULT-II
- Turn ignition witch ON and wait at least 1 second.
- Select "DATA MONITOR" mode with CONSULT-II.
- Set shift lever to D position and wait at least 3 seconds.
- Set shift lever to P position.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition witch ON and wait at least 1 second.
- Set shift lever to D position and wait at least 3 seconds.
- Set shift lever to P position.
- Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
- If DTC is detected, go to "DIAGNOSTIC PROCEDURE ."
With GST
Follow the procedure "With CONSULT-II" above.