Stop Lamp Switch

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect stop lamp switch harness connector.

Fig 1: Identifying ASCD Brake Switch And Stop Lamp Switch
Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.

BRAKE PEDAL SPECIFICATION

Conditions	Continuity
Brake pedal: Fully released	Should not exist
Brake pedal: Depressed	Should exist

Fig 2: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2

Courtesy of NISSAN MOTOR CO., U.S.A.

If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step 2 again.