Bank 2

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: EC-IVCB2-01 - Wiring Diagram

Courtesy of NISSAN MOTOR CO., U.S.A.

Specification data are reference values and are measured between each terminal and ground. Pulse signal is measured by CONSIULT-II.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.

ECM INSPECTION TABLE (BANK 2)

TERMINAL NO.

WIRE COLOR

ITEM

CONDITION

DATA (DC Voltage)

V/W

Intake valve timing control solenoid valve (Bank 2)

[Engine is running]

Warm-up condition
Idle speed

BATTERY VOLTAGE (11 - 14V)

[Engine is running]

Warm-up condition
Engine speed: 2, 000 rpm

7 - 12V⁽¹⁾

Courtesy of NISSAN MOTOR CO., U.S.A.

111

W/B

ECM relay
(Self shut-off)

[Engine is running]
[Ignition switch: OFF]

For a few seconds after turning ignition switch OFF

0 - 1.5V

[Ignition switch: OFF]

More than a few seconds after turning ignition switch OFF

BATTERY VOLTAGE (11 - 14V)

119
120

R/G
R/G

Power supply for ECM

[Ignition switch: ON]

BATTERY VOLTAGE (11 - 14V)

⁽¹⁾	Average voltage for pulse signal (Actual pulse signal can be confirmed by oscilloscope.)