Washer Fluid Reservoir

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Remove the front fender protector RH. Refer to "REMOVAL AND INSTALLATION OF FRONT FENDER PROTECTOR ".
Remove clip, then remove washer fluid reservoir filler neck from washer fluid reservoir.

Fig 1: Locating Washer Fluid Reservoir Clip
Courtesy of NISSAN NORTH AMERICA, INC.
Disconnect front and rear washer hoses.
Disconnect front and rear washer motor connector.
Disconnect washer fluid level sensor connector.

Fig 2: Identifying Washer Fluid Level Sensor Connector With Front And Rear Washer Motor Connector
Courtesy of NISSAN NORTH AMERICA, INC.
Remove washer fluid reservoir screws and remove washer fluid reservoir.

Fig 3: Locating Washer Fluid Reservoir Screws
Courtesy of NISSAN NORTH AMERICA, INC.

Installation

Installation is in the reverse order of removal.

CAUTION: After installation, add water up to the upper level of the washer fluid reservoir inlet and check for water leaks.