LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1089 (Interior) >> Removal And Installation >> Body Side Trim >> Removal and Installation >> Center Pillar Lower Finisher

Center Pillar Lower Finisher

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Removal

  1. Partially remove front and rear door welts as necessary.
  2. Remove the seat belt anchor. Refer to "REMOVAL AND INSTALLATION ".
    • On RH side, disconnect seat belt tension sensor.
  3. Remove the front and rear kick plates. Refer to the KICK PLATES  procedure in this article.
  4. Remove the center pillar lower finisher.

Installation

Installation is in the reverse order of removal.

scientia non olet · About LEMON Manuals