LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1086 (Parking Brake System) >> Removal And Installation >> Parking Brake Control >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument lower panel LH. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the front carpet. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the console floor bracket.
  4. Remove the parking brake control adjusting nut.
    CAUTION: Do not reuse adjusting nut after removing it.
  5. Remove the lock plate from the front cable.
  6. Remove the front parking brake cable bolt and nut.
  7. Disconnect the return spring from equalizer.
  8. Disconnect the front parking brake cable from the equalizer and remove front cable.
  9. Remove the rear disc rotors. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
    Fig 1: Identifying Adjusting Nut
    G04902235Courtesy of NISSAN NORTH AMERICA, INC.
  10. Remove the parking brake shoes, and disconnect the rear cables from the toggle levers. Refer to "REMOVAL AND INSTALLATION ".
  11. Remove the spare tire.
  12. Remove the equalizer from right and left rear cables.
  13. Remove the right and left rear cable bolts and nuts, then remove the right and left rear cables.
scientia non olet · About LEMON Manuals