LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Rear Final Drive (R230)) >> Removal And Installation >> Carrier Cover >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a 3 mm (0.12 in) bead of sealant to the mating surface of the carrier cover as shown.
    CAUTION: Remove any old sealant adhering to the mating surfaces. Also remove any moisture, oil, or foreign material adhering to the application and mating surfaces.
  2. Install the carrier cover to the gear carrier. Tighten the bolts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
  3. Install the rear final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
    Fig 1: Identifying Carrier Cover Sealant Applying Surface
    G04901931Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Fill the rear final drive assembly with recommended differential gear oil. Refer to DIFFERENTIAL GEAR OIL .
scientia non olet · About LEMON Manuals