LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Transfer Case (TX15B)) >> System Description >> Diagnosis System (Transfer Control Unit) >> CONSULT Function (ALL MODE AWD/4WD) >> Self Diagnostic Result

Self Diagnostic Result

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Operation Procedure

  1. Connect "CONSULT".
  2. With engine at idle, touch "SELF-DIAG RESULTS".

    Display shows malfunction experienced since the last erasing operation.

    NOTE: The details for "TIME" are as follows:
    • "0": Error currently detected with transfer control unit.
    • Except for "0": Error detected in the past and memorized with transfer control unit.

Detects frequency of driving after DTC occurs (frequency of turning ignition switch "ON/OFF").

How to Erase Self-diagnostic Results

  1. Perform applicable inspection of malfunctioning item and then repair or replace.
  2. Start engine and select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT.
  3. Touch "ERASE" on CONSULT screen to erase DTC memory.
    CAUTION: If memory cannot be erased, perform applicable diagnosis.
scientia non olet · About LEMON Manuals