LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Transfer Case (TX15B)) >> Removal And Installation >> Air Breather Hose >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure there are no pinched or restricted areas on each air breather hose caused by folding or bending when installing it.
  1. Install each air breather hose into the breather tube (metal connector) until the hose end reaches the end of the curved section. Set each air breather hose with paint mark facing upward.
    • A: Transfer control device air breather hose
    • B: A/T air breather hose
    • C: Paint marks
    • D: Transfer air breather hose
      Fig 1: Installing Air Breather Hose Into Breather Tube
      G05940537Courtesy of NISSAN NORTH AMERICA, INC.
  2. Install transfer control device air breather hose and transfer air breather hose on clip A and clip B with the paint mark facing upward.
    Fig 2: Identifying Transfer Control Device Air Breather Hose And Transfer Air Breather Hose, Paint Mark, Clips A And B
    G04898509Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install clip C on transfer control device air breather hose and transfer air breather hose with the paint mark matched.
    Fig 3: Identifying Transfer Control Device Air Breather Hose, Transfer Air Breather Hose And Clip C
    G04898510Courtesy of NISSAN NORTH AMERICA, INC.
  4. Install transfer control device air breather hose and transfer air breather hose on clip D with the paint mark facing upward.
    Fig 4: Identifying Transfer Control Device Air Breather Hose, Transfer Air Breather Hose, Paint Mark And Clip D
    G04898511Courtesy of NISSAN NORTH AMERICA, INC.
  5. Install transfer air breather hose into the breather tube (transfer, metal connector) until the hose end reaches the base of the tube. Set transfer air breather hose with paint mark facing upward.
    Fig 5: Identifying Transfer Air Breather Hose And Paint Mark
    G04901606Courtesy of NISSAN NORTH AMERICA, INC.
  6. Install transfer control device air breather hose into transfer control device (case connector) until the hose end reaches the base of the tube. Set transfer control device air breather hose with paint mark facing forward.
    Fig 6: Identifying Transfer Control Device Air Breather Hose And Paint Mark
    G04898513Courtesy of NISSAN NORTH AMERICA, INC.