LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Transfer Case (TX15B)) >> DTC/Circuit Diagnosis >> DTC P1817: Actuator Motor >> Component Inspection >> Transfer Relay

Transfer Relay

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "OFF". (Stay for at least 5 seconds.)
  2. Remove transfer shift high relay and transfer shift low relay 2. Refer to "COMPONENT PARTS LOCATION ".
  3. Apply 12V direct current between transfer shift high and low relay terminals 1 and 2.
  4. Check continuity between relay terminals 3 and 4, and 3 and 5.
    Terminal Condition Continuity
    3 - 4 12V direct current supply between terminals 1 and 2 No
    OFF Yes
    3 - 5 12V direct current supply between terminals 1 and 2 Yes
    OFF No
    Fig 1: Checking Continuity Between Relay Terminals 3 And 4, 3 And 5
    G04898443Courtesy of NISSAN NORTH AMERICA, INC.
  5. If the inspection results are abnormal replace the transfer shift high or low relay.
scientia non olet · About LEMON Manuals