EVAP Canister Control Pressure Sensor

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Remove left rear tire and wheel. Refer to "ADJUSTMENT ".
Remove left rear fender protector. Refer to "REMOVAL AND INSTALLATION OF REAR FENDER PROTECTOR ".
Disconnect the EVAP control pressure sensor connector.
Remove the EVAP canister control pressure sensor and O-ring.
CAUTION: Do not reuse O-ring.

Installation

Installation is in the reverse order of removal.

CAUTION: Do not reuse O-ring.