LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Transfer Case (ATX14B)) >> Removal And Installation >> Transfer Motor >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply ATF to the new O-ring and install it to the transfer motor.
    CAUTION: Do not reuse O-rings.
  2. Fit the double-flat end of the transfer motor shaft into the slot of the sub-oil pump assembly. Then tighten to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
    CAUTION: Be sure to install connector bracket.
    Fig 1: Identifying Sub-Oil Pump Assembly And O-Ring
    G08165989Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install the transfer motor air breather hose to the transfer motor. Refer to "REMOVAL AND INSTALLATION ".
  4. Connect the transfer motor connector.
  5. Check the transfer fluid. Refer to "INSPECTION ".
  6. Start the engine for one minute. Then stop the engine and recheck the transfer fluid. Refer to "INSPECTION ".
scientia non olet · About LEMON Manuals