LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Transfer Case (ATX14B)) >> DTC/Circuit Diagnosis >> DTC P1826: Transfer Fluid Temperature >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF. (Stay for at least 5 seconds.)
  2. Disconnect transfer terminal cord assembly harness connector.
  3. Check resistance between transfer terminal cord assembly terminals 2 and 3.
    Temperature °C (°F) Resistance (Approx.)
    20 (68) 2.5 kΩ
    80 (176) 0.3 kΩ
    Fig 1: Checking Resistance Between Transfer Terminal Cord Assembly Terminals 2 And 3
    G08165883Courtesy of NISSAN NORTH AMERICA, INC.
  4. If the inspection results are abnormal replace the transfer fluid temperature sensor. Refer to "COMPONENT PARTS LOCATION ".
scientia non olet · About LEMON Manuals