LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1061 (Front Axle) >> Unit Removal And Installation >> Drive Shaft >> VK56DE >> VK56DE: Removal and Installation >> Removal

VK56DE: Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wheel and tire using power tool.
  2. Remove engine under cover using power tool.
  3. Remove wheel sensor harness from mount on knuckle, then disconnect wheel sensor harness connector.
    CAUTION: Do not pull on wheel sensor harness.
  4. Remove wheel hub and bearing assembly. Refer to "REMOVAL AND INSTALLATION ".
    • It is not necessary to remove wheel sensor from wheel hub when wheel hub is not being replaced.
    • Carefully feed wheel sensor harness through hole in splash shield.
  5. Separate upper link ball joint stud from steering knuckle using Tool.
    • Support lower link with jack.

      Tool number: ST29020001 (J-24319-01) 

      Fig 1: Separating Upper Link Ball Joint Stud From Steering Knuckle
      G05883819Courtesy of NISSAN NORTH AMERICA, INC.
  6. Remove drive shaft mounting bolts from front final drive.
  7. Remove drive shaft assembly.
    CAUTION:
    • When removing drive shaft, do not apply an excessive angle to drive shaft joint. Also be careful not to excessively extend slide joint.
scientia non olet · About LEMON Manuals