LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1058 (Door & Lock (With Intelligent Key System)) >> Removal And Installation >> Hood >> Fitting Adjustment >> Clearance And Surface Height Adjustment

Clearance And Surface Height Adjustment

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to "REMOVAL AND INSTALLATION ".
  2. Loosen the hood lock assembly and adjust the rubber bumpers until the surface height of the hood becomes 1 mm (0.04 in) lower than the fender.
  3. Engage the hood striker and temporarily tighten.
  4. Check the lock and striker for looseness.
  5. Tighten the bolts to specification.
  6. Adjust the surface height of the hood according to the fitting standard dimension by rotating right and left rubber bumpers.
  7. Install the front grille. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals