LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1055 (Maintenance) >> Periodic Maintenance >> Chassis And Body Maintenance >> Transfer Fluid >> TRANSFER FLUID: Replacement >> Filling

TRANSFER FLUID: Replacement: Filling

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the filler plug and gasket.
  2. Fill the transfer with new fluid until the fluid level reaches the specified limit near the filler plug hole.

    Fluid grade and capacity: Refer to  "FOR USA AND CANADA: INTRODUCTION TO PERIODIC MAINTENANCE " (United States and Canada) or "FOR MEXICO: PERIODIC MAINTENANCE SCHEDULE " (Mexico).

    Fig 1: Checking Transfer Fluid Level From Filler Plug Hole
    G04901437Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Carefully fill fluid. (Fill up for approx. 3 minutes.)
  3. Leave the vehicle for 3 minutes, and check fluid level again.
  4. Install the filler plug with a new gasket to the transfer. Tighten to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
CAUTION: Do not reuse gasket.


  1. Remove the filler plug and gasket.
  2. Fill the transfer with new fluid until the fluid level reaches the specified limit near the filler plug hole.

    Fluid grade and capacity: Refer to  "FOR USA AND CANADA: FLUIDS AND LUBRICANTS ".

    Fig 1: Checking Transfer Fluid Level
    G04896924Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Carefully fill fluid. (Fill up for approx. 3 minutes.)
  3. Leave the vehicle for 3 minutes, and check fluid level again.
  4. Install the filler plug with a new gasket to the transfer. Tighten to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
CAUTION: Do not reuse gasket.
scientia non olet · About LEMON Manuals