LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1051 (Engine Lubrication System (VQ40DE)) >> Removal And Installation >> Oil Cooler >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain engine coolant from radiator and cylinder block. Refer to "CHANGING ENGINE COOLANT " and "DISASSEMBLY AND ASSEMBLY ".
  2. Remove engine front under cover and air dam using power tool. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect water hoses from oil cooler.
    CAUTION: Perform this step when engine is cold.
  4. Remove oil filter. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove connector bolt, oil cooler, and O-ring.
CAUTION: Do not reuse O-ring.
scientia non olet · About LEMON Manuals