DTC Confirmation Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT

Turn ignition switch "ON". (Do not start engine.)
Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
Start engine and maintain the following conditions for at least 5 consecutive seconds.
VHCL/S SE-A/T: 80 km/h (50 MPH) or more

ACCELE POSI: 0.5/8 - 1.0/8

SLCT LVR POSI: "D" position

Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test .
If DTC is detected go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT".