Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC
With CONSULT
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF DIAG RESULTS" mode for "TRANSMISSION" with CONSULT.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Perform "DTC CONFIRMATION PROCEDURE ".
  Is the "P0700" displayed again?
  
  YES: Replace the control valve with TCM. Refer to "REMOVAL AND INSTALLATION ".
  
  NO: INSPECTION END