LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1048 (Exterior) >> Removal And Installation >> Rear Bumper >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH and RH rear combination lamps. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the mudguards (if equipped). Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the rear fender protectors. Refer to "REMOVAL AND INSTALLATION OF REAR FENDER PROTECTOR ".
  4. Remove the LH and RH rear fascia strut lower bolts.
  5. Remove the rear fascia lower stay bolts.
  6. Remove the fascia front upper bolts near the wheel opening.
  7. Release the left pinch rail clips and remove the LH side of rear bumper fascia from the quarter panel.
  8. Release the right pinch rail clips and remove the RH side of the rear bumper fascia from the quarter panel.
  9. Remove the fascia rear upper bolts near the rear combination lamps LH/RH.
  10. Remove the rear bumper fascia.
  11. Disconnect the harness on left side of tow hitch.
  12. Detach the INTELLIGENT-KEY antenna, if equipped from the rear bumper reinforcement, then remove rear bumper reinforcement.
  13. Remove the drafter duct from the lower side of LH quarter panel.
  14. Remove the rear valance nuts and bolts, then remove the rear valance.
scientia non olet · About LEMON Manuals