Diagnosis Procedure

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Register TPMS transmitter IDs

MALFUNCTION CODE NO. 31, 32, 33, 34, 41, 42, 43, 44, 45, 46, 47 OR 48 (DTC C1712, C1713, C1714, C1715, C1720, C1721, C1722, C1723, C1724, C1725, C1726 OR C1727)

PERFORM ID REGISTRATION
1. Carry out ID registration of all transmitters. Refer to "ID REGISTRATION PROCEDURE ".
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
  GO TO 2
REPLACE TRANSMITTER
1. Check low tire pressure warning lamp again for flashing, replace malfunctioning transmitter. Refer to "TRANSMITTER (PRESSURE SENSOR) ".
2. Carry out ID registration of all transmitters.
  Can ID registration of all transmitters be completed?
  
  YES: GO TO 3
  
  NO: GO TO "DIAGNOSIS PROCEDURE ".
DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
2. Check all tire pressures with CONSULT within 5 minutes.
  Does DATA MONITOR ITEM display tire pressure as normal without any warning lamp?
  
  YES: Inspection End.
  
  NO: Replace malfunctioning transmitter, and perform Step 3 again.