LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1047 (Tires, Wheels & Tire Pressure Monitoring System (TPMS)) >> Basic Inspection >> Inspection And Adjustment >> ID Registration Procedure >> Id Registration Without Transmitter Activation Tool

Id Registration Without Transmitter Activation Tool

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 or Signal Tech II Tool J-50190 before ID registration can be performed.
  1. Connect CONSULT.
  2. Select ID REGIST under BCM.
  3. Adjust the tire pressures to the values shown in the table and drive the vehicle at 40 km/h (25 MPH) or more for a few minutes.
    Tire position Tire pressure kPa (kg/cm2 , psi)
    Front LH 250 (2.5, 36)
    Front RH 230 (2.3, 33)
    Rear RH 210 (2.1, 30)
    Rear LH 190 (1.9, 27)
  4. After completing all ID registrations, press END to complete the procedure.
    Activation tire position CONSULT
    Front LH YET
    ↓
    DONE
    Front RH
    Rear RH
    Rear LH
  5. Inflate all tires to proper pressure. Refer to "TIRE ".
scientia non olet · About LEMON Manuals