Connecting Rod Bend And Torsion

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Check connecting rod alignment using suitable tool.
Limit:

Bend: 0.15 mm (0.0059 in) per 100 mm (3.94 in) length

Torsion: 0.30 mm (0.0118 in) per 100 mm (3.94 in) length

Fig 1: Checking Connecting Rod Torsion Using Feeler Gauge
Courtesy of NISSAN NORTH AMERICA, INC.
If measurement exceeds the limit, replace connecting rod assembly.

Fig 2: Checking Connecting Rod Bend Using Feeler Gauge
Courtesy of NISSAN NORTH AMERICA, INC.