LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Engine Mechanical (VK56DE)) >> Removal And Installation >> Intake Valve Timing Control >> Intake Valve Timing Control Solenoid Valve (Bank 2) (RH) >> Removal

Intake Valve Timing Control Solenoid Valve (Bank 2) (RH): Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove drive belt. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect Intake valve timing control solenoid valve connector (Bank 2) (RH).
  3. Remove Intake valve timing control solenoid valve (Bank 2) (RH) (3) and O-ring (2) from Intake valve timing control solenoid valve cover (Bank 2) (RH) (1).
    CAUTION: Do not reuse O-ring.
    Fig 1: Identifying O-Ring, Intake Valve Timing Control Solenoid Valve And Cover (RH)
    G05378611Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals