LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Engine Mechanical (VK56DE)) >> Removal And Installation >> Intake Valve Timing Control >> Camshaft Position Sensor (PHASE) >> Removal

Camshaft Position Sensor (PHASE): Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect camshaft position sensor connector.
  3. Remove camshaft position sensor (2) and O-ring (3) from Intake valve timing control solenoid valve cover (LH) (1).
    CAUTION: Do not reuse O-ring.
    Fig 1: Identifying Camshaft Position Sensor, O-Ring And Intake Valve Timing Control Solenoid Valve Cover (LH)
    G05378614Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals