Inspection After Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

After installing fuel tubes, make sure there is no fuel leakage at connections in the following steps.

Apply fuel pressure to fuel lines by turning ignition switch ON (with engine stopped). Then check for fuel leaks at connections.
Start the engine and rev it up and check for fuel leaks at the connections.

Perform procedures for "Throttle Valve Closed Position Learning" after finishing repairs. Refer to "THROTTLE VALVE CLOSED POSITION LEARNING ".
If electric throttle control actuator is replaced, perform procedures for "Idle Air Volume Learning" after finishing repairs. Refer to "IDLE AIR VOLUME LEARNING ".