LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Engine Mechanical (VK56DE)) >> Preparation >> Preparation >> Commercial Service Tool

Commercial Service Tool

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
(Kent-Moore No.) Tool name Description
Power tool
G04878542
 Loosening screws, bolts and nuts
Spark plug wrench
G04899636
 Removing and installing spark plug
Valve seat cutter set
G04899638
 Finishing valve seat dimensions
Pulley puller
G04899639
 Removing crankshaft pulley
Piston ring expander
G04899640
 Removing and installing piston ring
Valve guide drift
G04899641
 Removing and installing valve guide
Intake & Exhaust: 
  1. 9.5 mm (0.374 in) dia  .
  2. 5.5 mm (0.217 in) dia  .
Valve guide reamer
G04899642
  1. Reaming valve guide hole
  2. Reaming hole for oversize valve guide

    Intake & Exhaust: 

    d1: 6.0 mm (0.236 in) dia  .

    d2: 10.175 - 10.196 mm (0.4006 - 0.4014 in) dia  .
Front oil seal drift
G04899643
 Installing front oil seal
Rear oil seal drift
G04899644
 Installing rear oil seal
(J-43897-18)
(J-43897-12)
Oxygen sensor thread cleaner
G04874775
 Reconditioning the exhaust system threads before installing a new Air Fuel Ratio sensor and heated oxygen sensor (Use with anti-seize lubricant shown below.)
  1. J-43897-18 (18 mm dia.) (0.71 in) 
  2. J-43897-12 (12 mm dia.) (0.55 in) 
Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907)
G04878228
 Lubricating A/F sensors and heated oxygen sensor thread cleaning tool when reconditioning exhaust system threads
scientia non olet · About LEMON Manuals