Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal. Note the following:

Intake Manifold

If stud bolts were removed from cylinder head, install them and tighten to the specified torque.
Intake manifold studs: 11.0 N.m (1.1kg-m, 8 ft-lb)
Tighten all nuts and bolts to the specified torque in two or more steps in numerical order as shown.
Intake manifold bolt and nuts

1st step: 7.4 N.m (0.75 kg-m, 65 in-lb)

2nd step and after: 29.0 N.m (3.0 kg-m, 21 ft-lb)

Fig 1: Tightening Sequence Of Intake Manifold Collector Bolt And Nuts
Courtesy of NISSAN NORTH AMERICA, INC.
Adjust the neutral position steering angle sensor.
Erase the CPU memory.