Removal and Installation: Installation

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal. Note the following:

Intake Manifold Collector

If stud bolts were removed from intake manifold, install them and tighten to the specified torque.
Tighten nuts and bolts in numerical order as shown.
Intake manifold collector bolts and nuts: 11.0 N.m (1.1 kg-m, 8 ft-lb)

Stud bolts: 6.9 N.m (0.7 kg-m, 61 in-lb)

Fig 1: Tightening Sequence Of Intake Manifold Collector Nuts And Bolts
Courtesy of NISSAN NORTH AMERICA, INC.

Electric Throttle Control Actuator

Tighten bolts in numerical order as shown.
Perform the "Throttle Valve Closed Position Learning" when harness connector of electric throttle control actuator is disconnected. Refer to "THROTTLE VALVE CLOSED POSITION LEARNING ".
Perform the "Idle Air Volume Learning" and "Throttle Valve Closed Position Learning" when electric throttle control actuator is replaced. Refer to "IDLE AIR VOLUME LEARNING ".

Fig 2: Tightening Sequence Of Electric Throttle Control Actuator Bolts
Courtesy of NISSAN NORTH AMERICA, INC.