LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1041 (SRS Airbag) >> Removal And Installation >> Crash Zone Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
  1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
  2. Remove crash zone sensor nuts and shield from support member.
  3. Disconnect the crash zone sensor harness connector.
  4. Remove crash zone sensor.
    Fig 1: Front Bumper, Crash Zone Sensor, Harness Connector And Support Member Nuts With Torque Specifications
    G04899536Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Replace crash zone sensor if it has been dropped or sustained an impact.
    • Do not disassemble crash zone sensor.
scientia non olet · About LEMON Manuals