LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1040 (Brake System) >> Removal And Installation >> Brake Tube And Hose >> Removal and Installation of Rear Brake Piping and Brake Hose >> Removal

Removal and Installation of Rear Brake Piping and Brake Hose: Removal

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wheel and tire assembly.
  2. Remove master cylinder reservoir cap.
  3. Remove brake tube from brake hose, using a suitable tool.
  4. Remove lock plate and brake hose from bracket.
    Fig 1: Identifying Brake Tube, Flare Nut, Lock Plate And Brake Hose
    G04899239
  5. Remove union bolt and copper sealing washers, then remove brake hose from caliper assembly.
    CAUTION: Do not reuse copper sealing washers.
    Fig 2: Identifying Brake Hose And Union Bolt
    G04899238
scientia non olet · About LEMON Manuals