Component Inspection

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SEAT BELT BUCKLE SWITCH
1. Turn ignition switch OFF.
2. Disconnect the seat belt buckle switch.
3. Check continuity between terminals 1 and 2.
Fig 1: Checking Continuity Between Seat Belt Buckle Switch LH Terminals 1 And 2
Courtesy of NISSAN MOTOR CO., U.S.A.

1 - 2

When seat belt is fastened: Continuity should not exist.

When seat belt is unfastened: Continuity should exist.

Is the inspection result normal?

YES: Inspection End.

NO: Replace the seat belt buckle switch LH.