LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Rear Suspension) >> On-Vehicle Repair >> Suspension Arm >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear suspension assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the connecting rod bracket from the suspension arm using power tools.
  3. Remove the two suspension arm bolts and nuts from the suspension member side of the suspension arm using power tools.
  4. Remove the ball joint cotter pin and lock nut using power tools.
    • Discard the cotter pin, use a new cotter pin for installation.
  5. Remove the suspension arm from the knuckle using Tool.

    Tool number: HT72520000 (J-25730-A) 

    CAUTION:
    • Do not damage ball joint when removing.
    • While using Tool, temporarily tighten the nut so as not to damage screw threads.
scientia non olet · About LEMON Manuals