Removal and Installation: Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse order of removal. For tightening torque. Refer to "Exploded View ".
CAUTION: Do not reuse non-reusable parts.
Perform final tightening of shock absorber assembly lower side (rubber bushing) under unladen condition with tires on level ground. Check wheel alignment. Refer to "Inspection and Adjustment ".
Adjust neutral position of steering angle sensor after checking the wheel alignment. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ".