LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Rear Suspension) >> On-Vehicle Repair >> Shock Absorber >> Disposal

Shock Absorber: Disposal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set shock absorber horizontally with the piston rod fully extended.
  2. Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position (•) from top as shown in the figure to release gas gradually.
    CAUTION:
    • Wear eye protection (safety glasses).
    • Wear gloves.
    • Be careful with metal chips or oil blown out by the compressed gas.
    NOTE:
    • Drill vertically in this direction (<=).
    • Directly to the outer tube avoiding brackets.
    • The gas is clear, colorless, odorless, and harmless.
      Fig 1: Identifying Dimension Of Hole On Shock Absorber For Releasing Gas
      G06556350Courtesy of NISSAN MOTOR CO., U.S.A.

    (A) : 20 - 30 mm (0.79 - 1.18 in) 

  3. Position the drilled hole downward and drain oil by moving the piston rod several times.
    CAUTION: Dispose of drained oil according to the law and local regulations.
scientia non olet · About LEMON Manuals