LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1034 (Rear Suspension) >> On-Vehicle Repair >> Rear Lower Link & Coil Spring >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the rear lower link bolt and nut from the suspension member side.
  2. Support the rear lower link by placing a suitable jack under the knuckle.
  3. Remove the rear lower link adjusting bolt and nut from the suspension member side using power tool.
    • Do not reuse the adjusting nut, use a new adjusting nut for installation.
  4. Slowly lower the jack to lower the rear lower link and coil spring.
  5. Remove the upper rubber seat, coil spring, and lower rubber seat from the rear lower link.
  6. Remove rear lower link bolt and nut from the suspension member side using power tool.
  7. Remove the rear lower link.
    Fig 1: Adjusting Toe-In Using Adjusting Bolt In Rear Lower Link
    G04902116Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals