Suspension Arm

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Check the suspension arm for damage, cracks, deformation and replace if necessary.
Check the rubber bushings for damage, cracks and deformation. Replace suspension arm if necessary.
Check the ball joint. Replace the suspension arm assembly if any of the following conditions exist:
- Ball stud is worn.
- Joint is hard to swing.
- Check if the swinging force (A), turning force (B), or vertical end play (C) is out of specification.
NOTE: Before checking specifications, turn the ball joint at least 10 revolutions so the ball joint is properly broken in.

Fig 1: Checking Axial Forces And End Play
Courtesy of NISSAN MOTOR CO., U.S.A.

Swinging force (A): Refer to "BALL JOINT ".

Turning torque (B): Refer to "BALL JOINT ".

Vertical end play (C): Refer to "BALL JOINT ".