Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY OUTPUT
CONSULT-III
- Turn ignition switch ON.
- Select "BATTERY SAVER" of BCM (BATTERY SAVER) active test item.
- While operating the test item, check voltage between BCM connector M17 terminal 4 and ground.
VOLTAGE REFERENCE CHART(+) (-) Test item Voltage BCM Ground BATTERY SAVER Connector Terminal M17 4 OFF 0 V ON Battery voltage Courtesy of NISSAN MOTOR CO., U.S.A.
Is the inspection result normal?
YES: GO TO 2
NO: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY OPEN CIRCUIT
- Turn ignition switch OFF.
- Disconnect the following connectors.
- BCM M17
- Front room/map lamp assembly
- Vanity mirror lamp LH
- Vanity mirror lamp RH
- Foot lamp LH
- Foot lamp RH
- Front step lamp LH
- Front step lamp RH
- Rear step lamp LH
- Rear step lamp RH
- Trunk room lamp
- Check continuity between BCM connector M17 terminal 4 and each interior room lamp connector.
CONTINUITY REFERENCE CHARTBCM Each interior room lamp Continuity Connector Terminal Connector Terminal M17 4 Front room/map lamp assembly R8 1 Yes Vanity mirror lamp LH R3 2 Vanity mirror lamp RH R9 2 Foot lamp LH M99 1 Foot lamp RH M100 1 Front step lamp LH D11 1 Front step lamp RH D109 1 Rear step lamp LH D206 1 Rear step lamp RH D301 1 Trunk room lamp B36 1 Is the inspection result normal?
YES: GO TO 3
NO: Repair the harness or connectors.
- CHECK BATTERY SAVER OUTPUT/POWER SUPPLY SHORT CIRCUIT
Check continuity between BCM connector M17 terminal 4 and ground.
CONTINUITY REFERENCE CHART
| BCM | Ground | Continuity | |
| Connector | Terminal | ||
| M17 | 4 | No | |
Is the inspection result normal?
YES: Replace the interior room lamp. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair the harness or connectors.