Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK KEY SLOT ILLUMINATION OUTPUT SIGNAL
Check voltage between key slot connector and ground.
VOLTAGE SPECIFICATIONTerminals Condition Key slot illumination Voltage (V) (Approx.) (+) (-) Key slot connector Terminal M40 6 Ground Intelligent Key inserted OFF Battery voltage Intelligent Key removed ON 0 Is the inspection result normal?
YES: GO TO 6
NO: GO TO 2
- CHECK KEY SLOT POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect key slot connector.
- Check voltage between slot connector and ground.VOLTAGE SPECIFICATION
Terminals Voltage (V) (Approx.) (+) (-) Key slot connector Terminal M40 1 Ground Battery voltage 5 Is the inspection result normal?
YES: GO TO 3
NO: Repair or replace key slot power supply circuit.
- CHECK KEY SLOT GROUND CIRCUIT
Check continuity between key slot connector and ground.
CONTINUITY CHARTKey slot connector Terminal Ground Continuity M40 7 Yes Courtesy of NISSAN MOTOR CO., U.S.A.
Is the inspection result normal?
YES: GO TO 4.
NO: Repair or replace key slot ground circuit.
- CHECK KEY SLOT CIRCUIT
- Turn ignition switch OFF.
- Disconnect BCM and key slot connector.
- Check continuity between BCM connector and key slot connector.CONTINUITY CHART
BCM connector Terminal Key slot connector Terminal Continuity A: M19 80 B: M40 6 Yes - Check continuity between BCM connector and ground.CONTINUITY CHART
BCM connector Terminal Ground Continuity A: M19 80 No Is the inspection result normal?
YES: GO TO 5
NO: Repair or replace harness between BCM and key slot.
- CHECK KEY SLOT
Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 6
NO: Replace key slot.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Inspection End.