Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK INTELLIGENT KEY WARNING BUZZER
Check voltage between BCM connector and ground.
VOLTAGE SPECIFICATIONTerminals Warning buzzer operation condition Voltage (V) (Approx.) (+) (-) BCM connector Terminal M21 144 Ground ON 0 OFF Battery voltage Is the inspection result normal?
YES: GO TO 5
NO: GO TO 2
- CHECK INTELLIGENT KEY WARNING BUZZER POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect Intelligent Key warning buzzer connector.
- Check voltage between Intelligent Key warning buzzer connector and ground.VOLTAGE SPECIFICATION
Terminals Voltage (V) (Approx.) (+) (-) Intelligent Key warning buzzer connector Terminal E28 1 Ground Battery voltage Courtesy of NISSAN MOTOR CO., U.S.A.
Is the inspection result normal?
YES: GO TO 3
NO: Repair or replace Intelligent Key warning buzzer power supply circuit.
- CHECK INTELLIGENT KEY WARNING BUZZER CIRCUIT
- Disconnect BCM connector.
- Check continuity between BCM connector and Intelligent Key warning buzzer connector.CONTINUITY CHART
A: BCM connector Terminal Intelligent Key warning buzzer connector Terminal Continuity M21 144 B: E28 3 Yes - Check continuity between BCM connector and ground.CONTINUITY CHART
BCM connector Terminal Ground Continuity A: M21 144 No Is the inspection result normal?
OK: GO TO 4
NG: Repair or replace harness between BCM and Intelligent Key warning buzzer.
- CHECK INTELLIGENT KEY WARNING BUZZER
Check "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 5
NO: Replace Intelligent Key warning buzzer.
- CHECK INTERMITTENT INCIDENT
Check "INTERMITTENT INCIDENT ".
Inspection End.