Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cowl top. Refer to "REMOVAL AND INSTALLATION ".
Remove roof side molding (if equipped). Refer to "REMOVAL AND INSTALLATION "
Remove inside mirror. Refer to "REMOVAL AND INSTALLATION ".
Partially remove the headlining (front edge). Refer to "REMOVAL AND INSTALLATION ".
Apply a protective tape around the windshield glass to protect the painted surface from damage.
- After removing moldings, remove glass using piano wire or power cutting tool (A) and an inflatable pump bag (B).
  
  Fig 1: Removing Glass Using Piano Wire Or Power Cutting Tool
  Courtesy of NISSAN MOTOR CO., U.S.A.
- If the windshield glass is to be reused, mark the body and the glass with mating marks.

WARNING: When cutting the glass from the vehicle, always wear safety glasses and heavy gloves to help prevent glass splinters from entering your eyes or cutting your hands.

CAUTION:

Be careful not to scratch the glass when removing.
Do not set or stand the glass on its edge. Small chips may develop into cracks.
When the windshield glass is to be reused, do not use a cutting knife or power cutting tool.