LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1030 (Glass & Window System) >> On-Vehicle Repair >> Rear Regulator >> Rear Door Glass Regulator >> Removal

Rear Door Glass Regulator: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door finisher. Refer to "REMOVAL AND INSTALLATION ".
  2. Temporarily reconnect the power window switch and raise/lower the door window until the glass bolts can be seen.
  3. Remove the glass bolts.
    Fig 1: Identifying Glass Bolts
    G05878375Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Raise the door glass and hold with a suction lifter.
  5. Remove the bolts and the regulator and guide channel from the panel.
    Fig 2: Identifying Regulator And Guide Channel Bolts
    G05878378Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Disconnect the connector from the regulator assembly.
    Fig 3: Identifying Regulator Assembly Connector
    G05878379Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove the regulator assembly.
scientia non olet · About LEMON Manuals