LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1030 (Glass & Window System) >> On-Vehicle Repair >> Rear Door Glass >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door finisher. Refer to "REMOVAL AND INSTALLATION ".
  2. Temporarily reconnect the power window switch and raise/lower the door window until the glass bolts can be seen.
  3. Remove the glass bolts, and place the glass on the inner bottom of the panel.
    Fig 1: Identifying Glass Bolts
    G05878375Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove the partition sash from the glass run.
  5. Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
    Fig 2: Identifying Partition Sash Bolt And Screw
    G05878376Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove the glass from the inside of the panel.
scientia non olet · About LEMON Manuals