Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door finisher. Refer to "REMOVAL AND INSTALLATION ".
Reconnect the window switch to raise/lower the door glass until the door glass bolts (A) can be seen.
Remove the door glass bolts (A).

Fig 1: Identifying Door Glass Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Raise the door glass and hold with a suction lifter (A).

Fig 2: Identifying Suction Lifter
Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect the window motor connector (A).

Fig 3: Identifying Window Motor Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the door module assembly mounting bolts.

Fig 4: Identifying Door Module Assembly Mounting Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the door module assembly.