Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front door finisher. Refer to "REMOVAL AND INSTALLATION ".
Remove the bolt hole covers.
Reconnect the window switch to raise/lower the door glass until the door glass bolts (A) can be seen.
Remove the door glass bolts (A).

Fig 1: Identifying Door Glass Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
While holding the door glass, raise it at the rear end to pull the door glass out of the sash toward the outside of the door.

Fig 2: Pulling Door Glass
Courtesy of NISSAN MOTOR CO., U.S.A.