LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1027 (Defogger) >> Component Diagnosis >> Rear Window Defogger Power Supply And Ground Circuit >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER SUPPLY CIRCUIT
    1. Turn ignition switch ON.
    2. Check voltage between rear window defogger connector and ground.
      TERMINAL VOLTAGE REFERENCE CHART

      Terminals Condition of rear window defogger switch Voltage (V) (Approx.)
      (+) (-)
      Rear window defogger connector Terminal
      B53 1 Ground ON Battery voltage
      OFF 0
      Fig 1: Checking Voltage Between Rear Window Defogger Connector And Ground
      G05047181Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: GO TO 2

      NO: GO TO  3

  2. CHECK GROUND CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect rear window defogger.
    3. Check continuity between rear window defogger connector and ground.
      TERMINAL CONTINUITY REFERENCE CHART

      Rear window defogger connector Terminal Ground Continuity
      B54 2 Yes
      Fig 2: Checking Continuity Between Rear Window Defogger Connector And Ground
      G05047182Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: GO TO  5

      NO: Repair or replace harness.

  3. CHECK HARNESS CONTINUITY 1
    1. Turn ignition switch OFF.
    2. Disconnect condenser and rear window defogger.
    3. Check continuity between condenser connector (A) and rear window defogger connector (B).
    TERMINAL CONTINUITY REFERENCE CHART

    Condenser connector Terminal Rear window defogger connector Terminal Continuity
    B52 (A) 1 B53 (B) 1 Yes
    Fig 3: Checking Continuity Between Condenser Connector And Rear Window Defogger Connector
    G05047183Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: GO TO 4

    NO: Replace condenser. Refer to "REMOVAL AND INSTALLATION ".

  4. CHECK HARNESS CONTINUITY 2
    1. Disconnect fuse block (J/B).
    2. Check continuity between fuse block (J/B) connector (A) and condenser connector (B).
      TERMINAL CONTINUITY REFERENCE CHART

      Fuse block (J/B) connector Terminal Condenser connector Terminal Continuity
      B4 (A) 10T B52 (B) 1 Yes
      11T
      Fig 4: Checking Continuity Between Fuse Block (J/B) Connector And Condenser Connector
      G05047184Courtesy of NISSAN MOTOR CO., U.S.A.

      Is the inspection result normal? 

      YES: GO TO  6

      NO: Replace or repair harness.

  5. CHECK FILAMENT

    Check filament.

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Refer to "INTERMITTENT INCIDENT ".

    NO: Repair filament. Refer to "INSPECTION AND REPAIR ".

  6. CHECK INTERMITTENT INCIDENT

    Check intermittent incident.

    Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal? 

    YES: Check the following.

    • Battery power supply circuit.
    • Fuse block (J/B).

    NO: Repair or replace the malfunctioning parts.