Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
1. Turn ignition switch ON.
2. Check "Self diagnostic result" with CONSULT-III.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure.
  See "DTC LOGIC ".
  
  Is the DTC B26E1 displayed again?
  
  YES: GO TO 2.
  
  NO: Inspection End.
REPLACE ECM
1. Replace ECM.
2. Go to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: DESCRIPTION ".
  Inspection End.