LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1025 (Seats) >> W/O Climate Controlled Seats >> On-Vehicle Repair >> Front Seat >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Confirm the position of connector before starting work.
  1. Slide the seat to the front most position.
  2. Remove the side fixing points (A).
    Fig 1: Removing Side Fixing Points
    G05876268Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Move the cover backward and remove the rear slide covers.
  4. Remove the rear mount bolts.
    Fig 2: Identifying Rear Slide Covers
    G05876269Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Slide the seat to the rear most position.
  6. Remove the front slide covers.
  7. Remove the front mount bolts.
    Fig 3: Identifying Front Slide Covers
    G05876270Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Disconnect battery negative and positive terminals.
    CAUTION:
    • Disconnect battery negative and positive terminals then wait for at least 3 minutes.
  9. Disconnect harness connector under the seat and remove harness clamps.
  10. Remove seat from the vehicle.
scientia non olet · About LEMON Manuals