LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1025 (Seats) >> W/O Climate Controlled Seats >> Disassembly And Assembly >> Front Seat >> Driver Side >> DRIVER SIDE: Disassembly and Assembly

DRIVER SIDE: Disassembly and Assembly

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

SEATBACK BOARD

Disassembly

  1. Remove the seat from the vehicle. Refer to "REMOVAL AND INSTALLATION "
  2. Release the clips (D) from the seat cushion springs.
  3. Pull the bottom of the backboard upward enough to release the inner clips (C).
  4. Insert the proper tool to release the pawls (B).
  5. Pull the backboard downward to disengage the hooks (A) and remove the backboard.
    Fig 1: Identifying Clips, Hooks And Pawls
    G05876278Courtesy of NISSAN MOTOR CO., U.S.A.

Assembly

Assembly is in the reverse order of disassembly.

THIGH EXTENSION ASSEMBLY

Disassembly

  1. Move the thigh extension to the front most position and release the trim cover clips (A).
  2. Remove the trim cover and foam (B).
    Fig 2: Identifying Trim Cover Clips And Foam
    G05876281Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Cut the thigh extension tethers and drill out the upper rivets (A) that connect the thigh extension tethers (B) to the thigh extension assembly (C).
    Fig 3: Identifying Upper Rivets, Thigh Extension Tethers And Thigh Extension Assembly
    G05876282Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Insert suitable tool into the thigh extension top panel and release the clip (A).
    Fig 4: Identifying Extension Assembly Clip
    G05876283Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Pull the thigh extension handle and remove the thigh extension assembly.
  6. Drill out the lower rivets that connect the thigh extension tethers to the seat frame assembly.

Assembly

  1. Replace the trim cover and clips and foam to the thigh extension assembly.
  2. Rivet the thigh extension tethers to the seat frame assembly mounting hole (A).
    Fig 5: Identifying Seat Frame Assembly Mounting Hole
    G05876284Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Align the thigh extension assembly on the top rail.
  4. Lift the thigh extension handle and slide the thigh extension assembly onto the seat.
    Fig 6: Aligning Thigh Extension Assembly On Top Rail
    G05876285Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Rivet the thigh extension tethers to the thigh extension assembly mounting hole (A).
    Fig 7: Identifying Thigh Extension Assembly Mounting Hole
    G05876286Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals