LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1023 (Parking Brake System) >> On-Vehicle Repair >> Parking Brake Control >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear wheel and tires using power tool.
  2. Remove instrument lower cover (LH) and lower knee protector. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect parking brake switch connector.
  4. Remove adjusting nut and discard, then loosen the front cable.
    CAUTION: Do not reuse adjusting nut.
    Fig 1: Identifying Adjusting Nut
    G04902235Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove parking brake pedal nuts and remove the parking brake pedal.
  6. Remove center console. Refer to "REMOVAL AND INSTALLATION ".
  7. Reposition the floor carpet aside.
  8. Separate the LH and RH rear cables from the equalizer then remove the front cable.
  9. Remove the front exhaust tube and the center exhaust tube. Refer to "REMOVAL AND INSTALLATION ".
  10. Remove the exhaust center tube heat insulator.
  11. Remove the rear brake disc rotors. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND ROTOR ".
  12. Disconnect the LH and RH rear cables from the toggle lever. Refer to "EXPLODED VIEW ".
  13. Remove the LH and RH rear cable bolts and nuts, then remove the LH and RH rear cables.
scientia non olet · About LEMON Manuals